Posted by Yoda on March 07, 2002 at 00:37:21:
In Reply to: TIGHT screws on carb cover posted by Rhubarb Sin on March 06, 2002 at 22:33:16:
> .... I merely stripped the heads
Please, everyone know that the carb top cover screws REQUIRE an impact screwdriver to remove. The factory torques them down tight. Now that yours are mashed, try cutting a slot in the heads with a Dremel disk that will accept a standard flat-blade screwdriver tip 'on an impact driver'. Grinding off the heads is not a good option, it will leave very little to grab with pliers.